Use and Care Guide
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: (800) 848- 6636
INTERNATIONAL: (440) 962- 2000 • FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: (888) 379-2720
WWW.CSI.MOEN.COM
Copyright Creativ
e Specialties International
Directions below are for installation into drywall. If installing product into a
stud, use the wood screws and washers provided only.
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes as indicated on the template.
4. Remove the template from the wall.
5. Fold the ends of the plastic toggle together and insert into each hole in the
wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and lightly tap into
activate anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew.
9. Place the mounting plate on the wall over the installed wall anchors with “UP”
facing you.
10. Insert screws through the mounting plate into the anchors. Tighten the
screws.
11. Assemble the towel bar and posts
12. While assembled, position each end post with setscrews facing down and
place over both mounting posts. Tighten the setscrew at the bottom of each
post.
Towel Bar
posts are constructed of
zinc. Bar is aluminum.
q
DN07
18CH
–
18” Towel Bar
Chrome Finish
q DN0718BN – 18” Towel Bar
Brushed Nickel Finish
q DN0724CH – 24” Towel Bar
Chrome Finish
q DN0724BN – 24” Towel Bar
Brushed Nickel Finish
Cleaning Instructions:
Stock Number:
______________________Towel Bar
By Creative Specialties
Materials:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN07
18 &
DN07
24
Iso Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1400
Installation Instructions: