Use and Care Guide

Pivoting Paper Holder post is a die
cast from the highest quality zinc alloy
(Zamac). Casting is plated
Mediterranean Bronze. The Pivoting
Paper Holder arm is stainless steel.
 DN1808BRB – Pivoting Paper
Holder
Mediterranean Bronze Finish
25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: (800) 848 -6636
I N TER N ATION AL: (440) 962 -2000  F AX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International Literature #BA1603
Cleaning Instructions:
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to your
product.
4. Remove the template from the w all.
5. Fold ends on the plastic toggle together and insert into each hole in the w all.
6. Lightly tap anchors until flush w ith the w all.
7. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening each
setscrew .
9. Place the mounting plate on the w all over the installed w all anchors w ith “UP”
facing you.
10. Insert screw s through the mounting plate into the anchors. Tighten screw s.
11. Place each assembly over the mounting posts w ith setscrew s facing dow n,.
Pivoting post w ith bar should be on the left side. Tighten both setscrew s.
Stock Number:___________________Pivoting Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Pivoting Paper Holder
DN1808
Whitley™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.