Instructions / Assembly

 DN4403BN – Robe Hook
Brushed Nickel Finish
 DN4403CH – Robe Hook
Chrome Finish
 DN4403ORB – Robe Hook
Oil Rubbed Bronze
25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: [phone]  F AX: (800) 848 -6636
I N TER NATI ON AL: [phone]  F AX: (440) 962 -2726
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International Literature # BA1516
Robe Hook post is die cast from
highest quality zinc alloy (Zamac).
Casting is plated in chrome, brushed
nickel or oil rubbed bronze.
Cleaning Instructions:
1. Remove mounting posts from the product assemblies by
loosening each screw.
2. Position the mounting plate on the wall at desired location with
“UP” facing you. Mark hole locations.
3. Drill 2 holes as marked using 5/16” drill bit.
4. Fold ends of the plastic toggle anchor together and insert into
each hole in the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to
activate anchor. Remove pin and repeat on the other anchor.
7. Place the mounting plate on the wall over the install wall anchors
with “UP” facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with the
setscrew facing down. Tighten setscrew.
Stock Number:______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN4403
Vale™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.