Specification Sheet

1. Remove mounting posts from the product assemblies by loosening
each setscrew.
2. Position the mounting plate on the wall at desired location with “UP”
facing you. Mark hole locations.
3. Drill 2 holes as marked using 5/16” drill bit.
4. Fold ends of the plastic toggle anchor together and insert into each
hole in the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to
activate anchor. Remove pin and repeat on the other anchor.
7. Place the mounting plate on the wall over the installed wall anchors
with “UP” facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with the setscrew
facing down. Tighten setscrew.
25300 AL MO E N D R IVE  NO RTH O L M STE D, OH 44 0 7 0
CO R P O RATE HE A D Q U ART ER S : (800 ) 3 2 1 -88 0 9  FA X: (800) 8 48 - 6 6 36
IN T E RNAT IO NA L : (440 ) 962 - 2 0 00  FA X: ( 4 4 0 ) 962 -2726
CU ST O MER S ERV ICE (USA): 800 -882 - 0 1 16  FA X: (88 8 ) 379 -2720
WWW . MO E N .CO M
Copyright Creative Specialties International 2010 Literature #BA1516
Robe Hook post is die cast from highest
quality zinc alloy (Zamac). Casting is
plated in chrome, brushed nickel or oil
rubbed bronze.
 DN4403BN – Robe Hook
Brushed Nickel Finish
 DN4403CH – Robe Hook
Chrome Finish
DN4403ORB – Robe Hook
Oil Rubbed Bronze Finish
Cleaning Instructions:
Stock Number:__________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
DN4403
Vale™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.