Full Product Manual

 DN4418BN – 18” Towel Bar
Brushed Nickel Finish
 DN4424BN – 24” Towel Bar
Brushed Nickel Finish
 DN4418CH – 18” Towel Bar
Chrome Finish
 DN4424CH – 24” Towel Bar
Chrome Finish
 DN4418ORB – 18” Towel Bar
Oil Rubbed Bronze Finish
 DN4424ORB – 24” Towel Bar
Oil Rubbed Bronze Finish
25300 AL MOEN D R I VE  N OR TH O LMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TERN ATI ONAL: [phone]  F AX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN .C OM
Copyright Creative Specialties International Literature # BA1519
Towel bar post is a die cast from the
highest quality zinc alloy (Zamac).
Casting is plated in chrome, brushed
nickel or oil rubbed bronze. Towel
bar is aluminum for brushed nickel
and chrome finishes and brass for oil
rubbed bronze.
Cleaning Instructions:
1. Position the mounting template on the w all in the desired location.
2. Using a level, align the template and tape it to the w all.
3. Drill tw o 5/16” holes at each mounting post location that corresponds to
your product.
4. Remove the template from the w all.
5. Fold ends of the plastic toggle together and insert into each hole in the
w all.
6. Lightly tap anchors until flush w ith the w all.
7. One at a time, insert plastic pin into each of the anchors and lightly tap
to activate anchor. Remove pin and repeat on all anchors.
8. Remove mounting posts from the product assemblies by loosening
each setscrew .
9. Place the mounting plate on the w all over the installed w all anchors
w ith “UP” facing you.
10. Insert screw s through the mounting plate into the anchors. Tighten
the screw s.
11. Assemble the tow el bar and posts.
12. While assembled, position each end post w ith setscrew s facing down
and place over both mounting posts. Tighten the setscrew at the
bottom of each post.
Stock Number:______________________Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN4418 & DN4424
Vale™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.