Specification Sheet
25300 AL MO E N D R IVE NO RTH O L M STE D, OH 44070
CO R P O RATE HE A D Q U ART ER S : (800 ) 3 2 1 -88 0 9 FA X: (800) 8 48 - 6 6 36
IN T E RNAT IO NA L : (440 ) 962 - 2 0 00 FA X: ( 4 4 0 ) 962 -2726
CU ST O MER S ERV ICE (USA): 800 -882 - 0 1 16 FAX: ( 888) 3 7 9 -2720
WWW . MO E N .CO M
Copyright Creative Specialties International 2010 Literature #BA1517
Prime1
Towel Ring post is die cast from
highest quality zinc alloy (Zmac).
Casting is plated in chrome, brushed
nickel or oil rubbed bronze. Towel
ring is aluminum for brushed nickel
and chrome finishes and brass for oil
rubbed bronze.
DN4486BN – Towel Ring
Brushed Nickel Finish
DN4486CH – Towel Ring
Chrome Finish
DN4486ORB – Towel Ring
Oil Rubbed Bronze Finish
Cleaning Instructions:
1. Remove mounting posts from the product assemblies by loosening each
setscrew.
2. Position the mounting plate on the wall at desired location with “UP” facing you.
Mark hole locations.
3. Drill 2 holes as marked using 5/16” drill bit.
4. Fold ends of the plastic toggle anchor together and insert into each hole in the
wall
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to activate anchor.
Remove pin and repeat on other anchor.
7. Place the mounting plate on the wall over the installed wall anchors with “UP”
facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with the setscrew facing down.
Tighten setscrew.
Stock Number:______________________Towel Ring
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Towel Ring
DN4486
Vale™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.