Dimensions Guide

Danbury Technical Specication
DN6718 & DN6724
18" & 24" Towel Bar
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
☐ DN6718CH – 18" Towel Bar
Chrome Finish
☐ DN6724CH – 24" Towel Bar
Chrome Finish
☐ DN6718ORB – 18" Towel Bar
Oil Rubbed Bronze Finish
☐ DN6724ORB – 24" Towel Bar
Oil Rubbed Bronze Finish
☐ DN6718BN – 18" Towel Bar
Brushed Nickel Finish
☐ DN6724BN – 24" Towel Bar
Brushed Nickel Finish
Towel Bar post is constructed of zinc.
Bar is brass.
Stock Number: Towel Bar
By MOEN
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): [phone] • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen, Inc.
1. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Remove each mounting post from the body by loosening the setscrew.
3. Place each mounting post on the template with notch facing down.
4. One at a time, place each anchor screw through the mounting post, centered
in the hole. Using a Phillips screw driver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall.
5. Only insert screw ½ to ¾ into wall.
6. After all screws are installed, tear the template away from the wall.
7. Tighten all 4 the screws. Do not over tighten.
8. Place skirt over each mounting post.
9. Assemble the Towel bar and posts.
10. While assembled, Position each end post with the setscrew down and place
over mounting post. Tighten the setscrew at the bottom of each base.
To preserve the ne nish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Length 18" 24"
Dim. A 18.00 24.00
Dim. B 20.38 26.38
A
B
3.000
(76.2)
3.440
(87.38)
2.380
(60.45)
.500
(12.7)