Full Product Manual

Towel bar posts are constructed of
zinc. Bar is brass.
 DN6718BN – 18” Towel Bar
Brushed Nickel Finish
 DN6724BN – 24” Towel Bar
Brushed Nickel Finish
 DN6718ORB – 18” Towel Bar
Oil Rubbed Bronze Finish
 DN6724ORB – 24” Towel Bar
Oil Rubbed Bronze Finish
Length 18" 24"
Dim. A 18.00 24.00
Dim. B 20.38 26.38
Cleaning Instructions:
25300 AL MOEN DRIVE  NORT H OL M ST ED, OH 44070 (800) 321 -8809 
FAX : [phone]  INT ERNAT IONAL: (4 4 0 ) 9 6 2 -2000 
FAX : [phone] CUS T OM ER SERVICE (USA ): 800 -882-0116
WWW.M OEN.COM
©Copyri ght Cre a ti ve Speci al ti e s Internati o n a l L i terature # B A1140
1. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Remove each mounting post from the body by loosening the setscrew.
3. Place each mounting post on the template with notch facing down.
4. One at a time, place each anchor screw through the mounting post, centered
in the hole. Using a Phillips screw driver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall.
5. Only insert screw ½ to ¾ into wall.
6. After all screws are installed, tear the template away from the wall.
7. Tighten all 4 the screws. Do not over tighten.
8. Place skirt over each mounting post.
9. Assemble the Towel bar and posts.
10. While assembled, Position each end post with the setscrew down and place
over mounting post. Tighten the setscrew at the bottom of each base.
Stock Number:______________________Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN6718 & DN6724
Danbury® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.