Specification Sheet

Oval Tilting Mirror posts are

constructed of zinc and mirror is

constructed of 5MM thick glass.

 DN6892BN – Oval Tilting Mirror

Brushed Nickel Finish

Cleaning Instructions:

1. Position the mounting template on the w all in the desired location. Using a

level, align the template and tape it to the w all.

2. Using a ¼” diameter drill bit, drill 4 holes as indicated on the template.

3. Remove template from the w all.

4. Remove the screw s and w ashers from each of the 4 w all anchors in the

hardw are kit. Set the screw s and w ashers aside for later use.

5. Insert the hollow w all anchors into the 4 holes in the w all by lightly tapping w ith

a hammer until flush.

6. Remove mounting posts from end post assembly by loosening each setscrew .

7. One at a time, place each mounting post over the w all anchors w ith notch

facing dow n. Insert the screw s and w ashers through the slots in the mounting

posts and into the w all anchors.

8. To activate the w all anchors, turn screw s until you feel increased resistance.

9. Loosen the 2 small screw s on each of the end posts.

10. With the back of the mirror facing you, slide the end posts into position on the

mirror (See figure 1). Align the screw s with the holes in the back plates.

Tighten all 4 screw s.

11. Place mirror assembly over the mounting posts on the w all (setscrew s facing

dow n). Tighten setscrew s.

Stock Number:___________________Oval Tilting Mirror

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Oval Tilting Mirror

DN6892

Sage® Technical Specification

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

25300 AL MOEN D RI VE  N OR TH OLMSTED , OH 44070

C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: (800) 848 -6636

I NTER N ATION AL: (440) 962 -2000  F AX: (440) 962-2726

C USTOMER SER VI C E (U SA): 800 -882-0116  F AX: (888) 379-2720

W WW . MOEN . C OM