Dimensions Guide

Bath Mat is made from polyvinyl
chloride with a pebbled top surface and
a waterproof adhesive backing.
 DN7050 – Bath Mat
Adhesive Backing
Photo Box Packaging
25300 AL MOEN DRIVE  NORT H OLMST ED, OH 4 4 070 (800 ) 3 2 1 -8809 
FAX: [phone]  INT E RNAT IONA L: (4 40) 9 62 -2000 
FAX: [phone] CUST OM ER SERV ICE (USA): 800 -882-0116
WWW.MOE N.COM
©Copyright Creative Specialties International Literature #BA1692
1. Prepare floor. Before beginning, make sure the tub or shower floor
is completely clean and dry.
2. Prepare mat. Peel away three inches of the paper backing along
the edge of the mat that will be located closest to the drain.
CAUTION: Do not touch the adhesive backing under the paper.
3. Position mat. Position the mat, paper side down, exactly where
you want it.
4. Secure mat. Gently press down the exposed section of the
adhesive against the floor surface. Then, reach under the mat and
slowly remove the remaining paper, stopping periodically to gently
press down the new exposed section of the mat. The mat will
adhere immediately. No drying is needed.
Stock Number:________________________Bath Mat
By Creative Specialties International
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Bath Mat
DN7050
Home Care Technical Specification