Use and Care Guide

Lindor™ Technical Specication
Robe Hook MY8703
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
MY8703BN – Robe Hook
Brushed Nickel
1. Remove the mounting post from the body by loosening the setscrew.
2. Position the mounting post on the wall at desired location with notch facing
down.
3. One at a time, place each anchor screw through the mounting post, centered
in the large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall. Do not over
tighten.
4. Place assembly over the mounting post, setscrew facing down.
5. Tighten setscrew.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Robe Hook is constructed of zinc.
Stock Number: _____________________ Robe Hook
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2017 Moen Incorporated. Moen is a registered trademark and Lindor is a trademark of
Moen Incorporated. All rights reserved.
2"
51 mm
3"
77 mm
3-7/16"
87 mm
2"
51 mm