Use and Care Guide

Lindor™ Technical Specication
18" & 24" Towel Bar MY8718, MY8724
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
MY8718BN – Towel Bar
Brushed Nickel
MY8724BN – Towel Bar
Brushed Nickel
1. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Remove both mounting posts by loosening each set screw.
3. Place each mounting posts on the template. To ensure correct alignment, it
is very important that the mounting post is installed straight.
4. One at a time, place each anchor screw through the mounting post, centered
in each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self-drill and tap into drywall. Only insert screw
½ to ¾ of the way into the wall.
5. After all screws are installed, tear the template away from the wall.
6. Tighten all four screws. Do not over tighten.
7. Place the square back plate over each mounting post.
8. Assemble the towel bar and posts.
9. While assembled, position each end post with the set screw down and place
over both mounting posts. Tighten the set screw at the bottom of each base.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Towel Bar Posts are constructed of zinc.
Bar is constructed of brass.
Stock Number: ______________________ Towel Bar
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2017 Moen Incorporated. Moen is a registered trademark and Lindor™ is a trademark of
Moen Incorporated. All rights reserved.
3-1/2"
91 mm
2"
52 mm
2"
51 mm
18"
457 mm
24"
610 mm