Use and Care Guide

Lindor™ Technical Specication
Towel Ring MY8786
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
MY8786BN – Towel Ring
Brushed Nickel
1. Remove mounting posts from the product assemblies by loosening each
setscrew.
2. Position the mounting plate on the wall at desired location with “UP” facing
you. Mark hole locations.
3. Drill 2 holes as marked using 5/16" drill bit.
4. Fold ends of the plastic toggle anchor together and insert into each hole in
the wall.
5. Lightlytapanchorsuntilushwiththewall.
6. One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor. Remove pin and repeat on other anchor.
7. Place the mounting plate on the wall over the installed wall anchors with
“UP” facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with the setscrew facing
down. Tighten setscrew.
Topreservethenenishofthisproduct,cleanonlywithasoftdampcloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Towel Ring Post is constructed of zinc.
Ring is aluminum.
Stock Number: _____________________ Towel Ring
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2017 Moen Incorporated. Moen is a registered trademark and Lindor is a trademark of
Moen Incorporated. All rights reserved.
2"
51 mm
2-5/8"
66 mm
5-7/16"
138 mm