Technical Specifications

Toothbrush and Soap Holders

are

stamped from Type 304 stainless

steel.

P17

40SS

–

Toothbrush Holder

Stainless Steel Finish

Concealed Screw Mounting

q P1760SS – Soap Holder

Stainless Steel Finish

Concealed Screw Mounting

Cleaning Instructions:

25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070 (800) 321-8809 •

FAX: (800) 848-6636 • INTERNATIONAL: (440) 962-2000 •

FAX: (440) 962

2726 CUSTOMER SERVICE (USA): 800

882

0116

1. Remove mounting bracket from back of fixture by loosening the set

screw.

2. Position unit on wall in desired location.

3. Lightly mark the outline of the base of the unit.

4. Center mounting bracket inside the outline.

5. Mark hole locations. Attach bracket to wall using 1 3/8” screws

(provided).

6. Mount base on bracket. Tighten set screw on the bottom.

Note: Wood blocking is preferable behind all wall surfaces.

If wood blocking is not available, the following optional fasteners are

suggested: Tile/Masonry – Plastic or Lead Anchors; Plaster/Drywall –

Toggle Bolts.

Stock Number:

________________Soap Dish & Tumbler

By CSI Bath Furnishings

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Toothbrush & Soap Holder

P1740, P1760

Stainless Steel Technical Specification

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

