Specification

ASCENT™ 90
Single Handle High Arc
Pullout Kitchen Faucet
Model: S71709 series
NOTE: THIS FAUCET IS DESIGNED TO BE INSTALLED
THRU 1 HOLE, 1-1/2" (38mm) MIN. DIA.
2-1/2" max deck
thickness
14-1/2"
(368mm)
12-11/32"
(314mm) Back Splash
3" (76mm) minimum
needed for handle
operation
10-1/2"
(267mm)
4-7/32”
(107mm)
6”
(152mm)
3"
(76mm)
11-17/64"
(286mm)
2-5/8"
(67mm)
29-1/2”
(750mm)
DESCRIPTION
• Metal construction with various finishes identified by suffix
• Hydrolock® quick connect installation
• Pullout spray with 68" braided hose
• Flexible supply lines with 3/8" compression fittings
• 360˚ rotating spout provides ability to install handle on either side
OPERATION
• Lever style handle
• Operates with less than 5 lbs. of force
• Operates in stream or spray mode in the pullout or retracted position
• When filling a vessel outside the sink, the pause feature conveniently
stops the flow of water as the wand passes over the counter top
FLOW
• Flow is limited to 1.5 gpm (5.7 L/min) at 60 psi
CARTRIDGE
• 1255™ Duralast™ cartridge
STANDARDS
• Third party certified to IAPMO Green, ASME A112.18.1/CSA B125.1 and all
applicable requirements referenced therein including NSF 61/9
• Meets CalGreen and Georgia SB370 requirements
• Contains no more than 0.25% weighted average lead content
• Complies with California Proposition 65 and with the Federal Safe
Drinking Water Act
• ADA for lever handle
• The backflow protection system in the device consists of two independently
operating check valves, a primary and a secondary which prevent backflow
WARRANTY
• Lifetime limited warranty against leaks, drips and finish defects
to the original consumer purchaser
• 5 year warranty if used in commercial installation
CRITICAL DIMENSIONS
(DO NOT SCALE)
FOR MORE INFORMATION CALL: 1-800-BUY-MOEN
www.moen.com
S p e c i f i c a t i o n s
CRITICAL DIMENSIONS
(DO NOT SCALE)
Rev. 9/11
There is more than 1 version of this model.
Page down to identify the version you have.