Spec Sheet

(91°)
8-5/16”
(211mm)
11-5/16”
(286mm)
2-1/2” Max Deck
Thickness
(64mm)
2-1/2”
(64mm)
12-3/8”
(314mm)
9-13/16”
(250mm)
4-1/8”
(105mm)
5-5/8”
(142mm)
6-5/16”
(160mm)
2-1/2”
(63mm)
2-1/2”
(63mm)
22-3/4”
(580mm)
90 DEGREE™
Single Handle High Arc
Pull Out Kitchen Faucet
Model: S7597 series
NOTE: THIS FAUCET IS DESIGNED TO BE INSTALLED
THRU 1 HOLE, 1-1/2” (38mm) DIA.
S p e c i f i c a t i o n s
TO ORDER PARTS CALL: 1-800-BUY-MOEN
www.moen.com
FAUCET DESCRIPTION
• Metal construction with various finishes identified by suffix
• Hydrolock® quick connect installation
• Pullout spray with 68” braided hose
• Flexible supply lines with 3/8" fittings connect directly to supply stops
• High arc spout provides height and reach to fill or clean large pots while
pull out wand provides the maneuverability for cleaning or rinsing
• 360˚ rotating spout provides ability to install handle on either side
OPERATION
• Lever style handle
• Operates in stream or spray mode in the pullout or retracted position
• When filling a vessel outside the sink, the pause feature conveniently stops
the water flow as the wand passes over the counter top
• Temperature controlled by 100˚ arc of handle travel
FLOW
• Flow is limited to 1.5 gpm (5.7 L/min) at 60 psi
CARTRIDGE
• 1255™ Duralast™ cartridge for Single-Handle Faucets
STANDARDS
• Third party certified to IAPMO Green, ASME A112.18.1/CSA B125.1 and all
applicable requirements referenced therein including NSF 61/9
• Meets CalGreen and Georgia SB370 requirements
• Contains no more than 0.25% weighted average lead content
• Complies with California Proposition 65 and with the Federal Safe Water
Drinking Act
• The backflow protection system in the device consists of two
independently operating check valves, a primary and a secondary which
prevent backflow
• ADA for lever handle
WARRANTY
• Lifetime limited warranty against leaks, drips and finish defects to the
original consumer purchaser
• 5 year warranty if used in commercial installations
CRITICAL DIMENSIONS
(DO NOT SCALE)
Rev. 9/11