Installation Guide

ManualsBrandsMOEN ManualsBathVestige Posi-Temp Trim Kit Shower Only in Brushed Nickel (Valve Not Included)

Installation Guide

Guía de Instalación

Guide d’installation

Thread seal tape

Cinta para sellar roscas

Ruban pour joints letés

5/32 Hex

Llave Hexagonal

Clé Hexagonale

7/64 Hex

Llave Hexagonal

Clé Hexagonale

Please Contact Moen First

For Installation Help, Missing or Replacement Parts

(USA)

1-800-BUY-MOEN (1-800-289-6636)

Mon - Fri 8:00 AM to 7:00 PM, Eastern

Sat. 9:00 AM to 3:00 PM Eastern

WWW.MOEN.COM

(Canada)

1-800-465-6130

Mon - Fri 7:30 AM to 8:00 PM, Eastern

WWW.MOEN.CA

Shower heads:

Standard 9.5 L/min (2.5 gpm) max. and High Eciency 7.6 L/min (2.0 gpm)

max. or less

For use with automatic compensating valves rated at 4.2 L/min (1.1 gpm)

or less

Por favor, contáctese primero con Moen

Para obtener ayuda de instalación, piezas faltantes o de recambio

01-800-718-4345

Lunes a viernes de 8:00 a 20:00 hs.

(Costa Este)

áb. 8:00 a 18:30 hs. (Costa Este)

WWW.MOEN.COM. MX

Roseta:

Estándar 9.5 L/min (2.5 gpm) máx. y alta eciencia 7.6 L/min (2.0 gpm) máx.

o menos

Para usarse con válvulas de compensación automática de 4.2 L/min (1.1

gpm) o menos

Veuillez d’abord contacter Moen

en cas de problèmes avec l’installation, ou pour obtenir toute pièce

manquante ou de rechange

1-800-465-6130

Du lundi au vendredi:

de 7 h 30 à 20 h, HE

WWW.MOEN.CA

Pommes de douche :

Standards 2,5 gpm (9,5 L/min) max. ou à haute ecacité 2,0 gpm max. (7,6

L/min) ou moins

À utiliser avec des soupapes de compensation automatiques dont le débit

nominal est de 4,2 L/min (1,1 gpm) ou moins

INS1223D - 8/14

ONE-HANDLE TUB/SHOWER

TRIM

MODELS T2501, T2502, T2502EP, T2502NH, T2503, T2503EP, T2503NH Series

MONOMANDO TERMINACIÓN

PARA TINA/REGADERA

MODELOS T2501, T2502, T2502EP, T2502NH, T2503, T2503EP, T2503NH Series

GARNITURE DE DOUCHE/

BAIGNOIRE À UNE POIGNÉE

MODÉLES T2501, T2502, T2502EP, T2502NH, T2503, T2503EP, T2503NH

HELPFUL TOOLS

For safety and ease of faucet replacement, Moen

recommends the use of these helpful tools.

HERRAMIENTAS ÚTILES

Para que el cambio de la llave sea fácil y seguro,

Moen le recomienda usar estas útiles herramientas.

OUTILS UTILES

Par mesure de sécurité et pour faciliter l’installation,

Moen suggère l’utilisation des outils suivants.

Summary of content (6 pages)

PAGE 1
INS1223D - 8/14 Installation Guide Guía de Instalación Guide d’installation Please Contact Moen First For Installation Help, Missing or Replacement Parts (USA) 1-800-BUY-MOEN (1-800-289-6636) Mon - Fri 8:00 AM to 7:00 PM, Eastern Sat. 9:00 AM to 3:00 PM Eastern WWW.MOEN.COM (Canada) 1-800-465-6130 Mon - Fri 7:30 AM to 8:00 PM, Eastern WWW.MOEN.CA Shower heads: Standard 9.5 L/min (2.5 gpm) max. and High Efficiency 7.6 L/min (2.0 gpm) max. or less For use with automatic compensating valves rated at 4.
PAGE 2
CAUTION — TIPS FOR REMOVAL OF OLD FAUCET: Always turn water supply OFF before removing existing faucet or disassembling the valve. Open faucet handle to relieve water pressure and ensure that complete water shut-off has been accomplished. PRECAUCIÓN — CONSEJOS PARA CAMBIAR LA LLAVE MEZCLADORA: Siempre CIERRE la toma de agua antes de quitar la llave existente o desmontar la válvula. Abra la llave para liberar la presión, y asegúrese de que esté bien cerrada el agua.
PAGE 3
1 Option / Opcion / Option 2 Option / Opcion / Option Option / Opcion / Option No sharp edges/burrs on end of pipe. No debe haber bordes afilados ni rebabas en el extremo del tubo. Aucunes arêtes vives ni bavures à l'extrémité du tuyau. 1 H 1 3 2 I I 2 Thread seal tape Cinta para sellar roscas Ruban pour joints filetés Thread seal tape Cinta para sellar roscas Ruban pour joints filetés 2 J 4 Option / Opcion / Option G 1 2" min. 2-3/4" max. (51mm-70mm) Barely tighten screw.
PAGE 4
INS1223D - 8/14 7 NO NON HC 8 9 L 1 1 2 C YES SI/OUI HC K D 2 M 10 12 11 2 To reduce maximum temperature go to step 12 . If not go to step 14 . 1 1 L M D Para reducir la temperatura máxima, vaya a paso 12 . Si no, vaya a paso 14 . K 2 D + 120oF (48oC) HOTTEST CALOR MÁXIMO PLUS CHAUDE Pour réduire la température maximale, passer à l'étape 12 . Sinon, passer à l'étape 14 .
PAGE 5
INS1223D - 8/14 13 14 1 S 3 1 L 1 Option / Opción / Option M K 2 N 2 2 P 5 7/64” R
PAGE 6
Moen Limited Lifetime Warranty Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the original consumer purchaser for as long as the original consumer purchaser owns their home (the “Warranty Period" for homeowners), that this faucet will be leak- and drip-free during normal use and all parts and finishes of this faucet will be free from defects in material and manufacturing workmanship.