Installation Guide

ManualsBrandsMOEN ManualsBathKingsley Single-Handle 1-Spray Tub and Shower Faucet Trim Kit with Valve in Brushed Nickel

Installation Guide

Guía de Instalación

Guide d’installation

Thread seal tape

Cinta para sellar roscas

Ruban pour joints letés

5/32 & 7/64 Hex

Llave Hexagonal

Clé Hexagonale

Sealant

Sellador

Mastic

HERRAMIENTAS ÚTILES

Para que el cambio de la llave sea fácil y

seguro, Moen le recomienda usar estas

útiles herramientas.

OUTILS UTILES

Par mesure de sécurité et pour faciliter

l’installation, Moen suggère l’utilisation des

outils suivants.

HELPFUL TOOLS

For safety and ease of faucet replacement,

Moen recommends the use of these

helpful tools.

Please Contact Moen First

For Installation Help, Missing or Replacement Parts

(USA)

1-800-BUY-MOEN (1-800-289-6636)

Mon - Fri 8:00 AM to 7:00 PM, Eastern

Sat. 9:00 AM to 3:00 PM Eastern

WWW.MOEN.COM

(Canada)

1-800-465-6130

Mon - Fri 7:30 AM to 8:00 PM, Eastern

WWW.MOEN.CA

Shower heads:

Standard 9.5 L/min (2.5 gpm) max. and High Eciency 7.6 L/min (2.0 gpm)

max. or less

For use with automatic compensating valves rated at 4.2 L/min (1.1 gpm) or

less

Por favor, contáctese primero con Moen

Para obtener ayuda de instalación, piezas faltantes o de recambio

01-800-718-4345

Lunes a viernes de 8:00 a 20:00 hs.

(Costa Este)

Sáb. 8:00 a 18:30 hs. (Costa Este)

WWW.MOEN.COM.MX

Roseta:

Estándar 9.5 L/min (2.5 gpm) máx. y alta eciencia 7.6 L/min (2.0 gpm) máx.

o menos

Para usarse con válvulas de compensación automática de 4.2 L/min (1.1

gpm) o menos

Veuillez d’abord contacter Moen

en cas de problèmes avec l’installation, ou pour obtenir toute pièce

manquante ou de rechange

1-800-465-6130

Du lundi au vendredi:

de 7 h 30 à 20 h, HE

WWW.MOEN.CA

Pommes de douche :

Standards 2,5 gpm (9,5 L/min) max. ou à haute ecacité 2,0 gpm max. (7,6 L/

min) ou moins

À utiliser avec des soupapes de compensation automatiques dont le débit

nominal est de 4,2 L/min (1,1 gpm) ou moins

INS796D - 8/14

ONE-HANDLE TUB/SHOWER TRIM

MODELS T3111, T3112, T3113 Series

MONOMANDO TERMINACIÓN PARA

TINA/REGADERA

MODELOS T3111, T3112, T3113 Series

GARNITURE DE DOUCHE/BAIGNOIRE

À UNE POIGNÉE

MODÉLES T3111, T3112, T3113

Summary of content (8 pages)

PAGE 1
INS796D - 8/14 Installation Guide Guía de Instalación Guide d’installation Please Contact Moen First For Installation Help, Missing or Replacement Parts (USA) 1-800-BUY-MOEN (1-800-289-6636) Mon - Fri 8:00 AM to 7:00 PM, Eastern Sat. 9:00 AM to 3:00 PM Eastern WWW.MOEN.COM (Canada) 1-800-465-6130 Mon - Fri 7:30 AM to 8:00 PM, Eastern WWW.MOEN.CA Shower heads: Standard 9.5 L/min (2.5 gpm) max. and High Efficiency 7.6 L/min (2.0 gpm) max. or less For use with automatic compensating valves rated at 4.
PAGE 2
A* * B1 G * B2 H *B B* I LL WA THIN C* J LL WA THIN K D L M E O N F P OPTION / OPCION / OPTION * Included with valve / Incluído con la mezcladora / Compris avec obturateur CAUTION — TIPS FOR REMOVAL OF OLD FAUCET: Always turn water supply OFF before removing existing faucet or disassembling the valve. Open faucet handle to relieve water pressure and ensure that complete water shut-off has been accomplished.
PAGE 3
INS796D - 8/14 1 2 Option / Opcion / Option 1 Option/Opcion/Option 1 G 2 3 Option / Opcion / Option E H 3 H Thread seal tape Cinta para sellar roscas Ruban pour joints filetés 1-1/2 min (38mm) 3 3/4 max (95mm) 2 Thread seal tape Cinta para sellar roscas Ruban pour joints filetés Sealant Sellante Mastic I 4 5 Option / Opcion / Option No sharp edges/burrs on end of pipe. No debe haber bordes afilados ni rebabas en el extremo del tubo. Aucunes arêtes vives ni bavures à l'extrémité du tuyau.
PAGE 4
9 8 7 B1 B1 D B2 B B1 J 3 B2 11 10 M If handle is pre-assembled go to step 12 . M Si se premonta la manija vaya al paso 12 . K Si la poignée est prémontée passez à l'étape 12 .
PAGE 5
INS796D - 8/14 13 12 14 O Q Q or/o/ou or/o/ou M M 15 17 16 To reduce maximum temperature go to step 18 . If not go to step 24 . Para reducir la temperatura máxima, vaya a paso 18 . Si no, vaya a paso 24 . 120F (48C) Pour réduire la température maximale, passer à l'étape 18 . Sinon, passer à l'étape 24 .
PAGE 6
18 Option / Opcion / Option 19 Option / Opcion / Option 20 Option / Opcion / Option 2 1 O Q or/o/ou M Q or/o/ou M 21 Option / Opcion / Option 22 Option / Opcion / Option 23 Option / Opcion / Option O Q Q or/o/ou or/o/ou M M 6
PAGE 7
INS796D - 8/14 24 P OPTIONS / OPCIONES / OPTIONS P 7
PAGE 8
Moen Limited Lifetime Warranty Moen products have been manufactured under the highest standards of quality and workmanship. Moen warrants to the original consumer purchaser for as long as the original consumer purchaser owns their home (the “Warranty Period" for homeowners), that this faucet will be leak- and drip-free during normal use and all parts and finishes of this faucet will be free from defects in material and manufacturing workmanship.