Use and Care Guide

Rinza™ Technical Specication
18 in. / 24 in. Towel Bar Y1118/Y1124
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
Y1118CH – 18" Towel Bar
Chrome Finish
Y1118BN – 18" Towel Bar
Brushed Nickel Finish
Y1118BL – 18" Towel Bar
Matte Black Finish
Y1124CH – 24" Towel Bar
Chrome Finish
Y1124BN – 24" Towel Bar
Brushed Nickel Finish
Y1124BL – 24" Towel Bar
Matte Black Finish
Tools Required: Phillips screwdriver, drill, 1/4” drill bit, hammer, level, tape
Hardware Kit Contents: 2 anchors, 1 hex wrench.
Note: Directions below are for installation into drywall. If installing product
into a stud, use the wood screws only.
1) Remove mounting posts from the product assemblies by loosening
each setscrew.
2) Position the mounting plate on the wall in the desired location and mark
holes at the Horizontal screw location on the template if installing into
drywall or vertical screw location if installing into a stud.
3) Drill 1/4” pilot holes in marked locations.
4)Lightlytapanchorsuntilushwiththewall.
5) Place each mounting plate over anchors and insert screws through post
into anchors.
6) Tighten screws.
7) Place posts over the mounting plates with setscrew facing down and
tighten setscrew.
Topreservethenenishofthisproduct,cleanonlywithasoftdampcloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
18 in. and 24 in. Towel Bar is constructed
of zinc.
Stock Number: Y1118 and Y1124 Towel Bar
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2019 Moen Incorporated. Moen is a registered trademark and Rinza is a trademark of
Moen Incorporated. All rights reserved.
18"
(457mm)
2"
(51mm)
3"
(76mm)
24"
(610mm)
20"
(508mm)
26"
(660mm)