Specification

Banbury™ Technical Specication
Mirror with Decorative Hardware Y2692
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
Y2692CH – Mirror with Decorative
Hardware
Chrome Finish
Y2692BN – Mirror with Decorative
Hardware
Brushed Nickel Finish
Y2692BRB – Mirror with Decorative
Hardware
Mediterranean Bronze Finish
Directions below are for installation into drywall. If installing product into a stud,
use the wood screws and washers provided only.
1. Remove the mounting bracket from the body by loosening the set screw.
2. Position the mounting template on the wall at desired location. Using a level,
align the template and tape it to the wall.
3. Drill 1/2" pilot holes in marked location, remove template from wall.
4. Place mounting bracket over holes, align and trace both parts.
5. Attach mounting bracket to wall using anchors in predrilled pilot holes.
6. Unscrew plastic nut from end post.
7. With the back of the mirror facing you, slide both end posts into position on
the mirror. Align the screw with the hole in the mirror.
8. Thread on plastic nut and hand tighten.
9. Place each post over the mounting bracket with setscrew down. Tighten both
setscrews.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Mirror with Decorative Hardware is
constructed of zinc.
Stock Number: ______________________________
Mirror with Decorative Hardware
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2019 Moen Incorporated. Moen is a registered trademark and Banbury is a trademark of
Moen Incorporated. All rights reserved.
19"
(483mm)
0.19"
(5mm)
2"
(51mm)
Dia.
1.45"
(37mm)
26"
(660mm)
19"
(483mm)
0.19"
(5mm)
2"
(51mm)
Dia.
1.45"
(37mm)
26"
(660mm)