Use and Care Guide
Y3103BN – Robe Hook
Brushed Nickel Finish
Y3103BRB – Robe Hook
Mediterranean Bronze Finish
Y3103CH – Robe Hook
Chrome Finish
25300 AL MO E N D R I VE NO RTH O L M S TE D, OH 4 4 0 70
CO R P O RAT E HE A D Q U A RT ER S : ( 8 00 ) 3 2 1 -88 0 9 FAX: ( 8 0 0 ) 8 4 8 - 6 6 3 6
IN T E R NAT IO N A L : (440 ) 9 6 2 - 2 0 00 F A X: ( 4 4 0 ) 962 -2726
CU S T O M ER S ER V ICE ( US A): 800 -882 - 0 1 1 6 FA X: (88 8 ) 3 7 9 - 2720
W WW . CSI . MOE N . C O M
Copyright Creative Specialties International Literature # BA1534
Robe Hook post is die cast from
highest quality zinc alloy (Zamac).
Casting is plated in Chrome, Brushed
Nickel or Mediterranean Bronze.
Cleaning Instructions:
1. Remove mounting plate from hardware pack.
2. Position the mounting plate on the wall at desired location with “UP”
facing you. Mark hole locations.
3. Drill 2 holes as marked using 5/16” drill bit.
4. Fold ends of the plastic toggle anchor together and insert into each hole
in the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor. Remove pin and repeat on other anchor.
7. Place the mounting plate on the wall over the installed wall anchors with
“UP” facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with setscrew facing
down and tighten setscrew.
Stock Number:______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
Y3103
Lindale™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.