Specification

Adler™ Technical Specication
Bathroom Accessory Suite YB0193
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
YB0193CH – Paper Holder,
Towel Ring, and Towel Bar
Chrome Finish
1. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Remove each mounting post from the body by loosening the set screw.
3. Place each mounting post on the template with notch facing down.
4. Mark the 2 large hole locations of each mounting bracket.
5. Attach each mounting bracket to the wall, using the wall anchors provided
6. Mount each base on the corresponding mounting bracket. Check and make
sure that the base set screw hole(s) are facing down. Assemble a set screw
to each base. Use the allen wrench included in hardware kit to tighten each
set screw and secure the assembly to the mounting bracket(s).
7. Tighten all 4 screws. Do not over tighten.
8. Place each post over the mounting plate (set screw down). Pivoting post with
bar to be on left side. Tighten both set screws.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Paper Holder is constructed of zinc.
Towel Bar Posts are constructed of zinc.
Bar is constructed of brass.
Towel Ring Post is constructed of zinc.
Ring is aluminum.
Stock Number: ___________________ Paper Holder,
Towel Bar, and Towel Ring By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2017 Moen Incorporated. Moen is a registered trademark and Adler is a trademark of
Moen Incorporated. All rights reserved.
See reverse side for dimensions