Dimensions Guide

2-1/8"
53mm
2-15/16"
74mm
8-3/8"
212mm
6-1/4"
159mm
Moen Accessories Technical Specication
Paper Holder YB0208
Stock Numbers: Dimensions:
YB0208CH – Paper Holder
Chrome
YB0208BN – Paper Holder
Brushed Nickel
YB0208BL – Paper Holder
Matte Black
Materials:
Paper Holder is constructed of zinc.
Cleaning Instructions:
To preserve the ne nish of this product, clean only with a soft damp
cloth. Dry well. Do not use commercial or abrasive cleaners.
Stock Number: _____________________ Paper Holder
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2016 Moen Incorporated. Moen is a registered trademark and Wynford is a trademark of
Moen Incorporated. All rights reserved.
Installation Instructions:
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Using the horizontal holes for drywall installation OR the vertical holes
for installation into a stud, mark the hole locations at each mounting post for your
corresponding product OR drill two ¼" pilot holes at the corresponding location.
4. Remove the template from the wall.
5. Using a #2 Phillips head screwdriver, screw the provided anchors into the wall
until ush.
6. Remove mounting post from the product assemblies by loosening each set screw
with the provided hex wrench.
7. One at a time, place each mounting post over the anchors (with the arrow facing
up) and insert provided screws through the post into the anchors.
8. Tighten screws.
9. Assemble the paper holder and posts.
10. While assembled, position each end post with setscrews facing down and place
over both mounting posts. Tighten the setscrew at the bottom of each post.