Specification Sheet

2.60"
(66)
2.60"
(66)
1.44"
(36.6)
1.44"
(36.6)
3.98"
(101)
ALIGN
™
Technical Specication
YB0402
Swiveling Double Robe Hook
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
☐ YB0402CH – Swiveling Double
Robe Hook
Chrome Finish
☐ YB0402BN – Swiveling Double
Robe Hook
Brushed Nickel Finish
☐ YB0402BL – Swiveling Double
Robe Hook
Matte Black Finish
Swiveling Double Robe Hook is
constructed of zinc.
Stock Number: YB0402 Swiveling Double
Robe Hook By MOEN
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): [phone] • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen, Inc.
To preserve the ne nish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Note: Directions below are for installation into drywall. If installing product into a stud,
use the wood screws only.
1 Remove mounting posts from the product assemblies by loosening each setscrew.
2 Position the mounting plate on the wall in the desired location and mark holes
at the Horizontal screw location on the template if installing into drywall or vertical
screw location if installing into a stud.
3 Drill 1/4” pilot holes in marked locations.
4 Lightly tap anchors until ush with the wall.
5 Place each mounting plate over anchors and insert screws through post into anchors.
6 Tighten screws.
7 Place posts over the mounting plates with setscrew facing down and tighten setscrew.