Specification Sheet

ALIGN
™
Technical Specication
YB0403
Robe Hook
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
☐ YB0403CH– Robe Hook
Chrome Finish
☐ YB0403BN– Robe Hook
Brushed Nickel Finish
☐ YB0403BL– Robe Hook
Matte Black Finish
Robe Hook is constructed of zinc.
Stock Number: YB0403 Robe Hook
By MOEN
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): [phone] • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen, Inc.
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 1/4" holes at each mounting post location that corresponds to your
product. (We recommend using the horizontal holes for drywall installation).
4. Remove the template from the wall.
5. Lightlytapanchorsuntilushwiththewall.
6. Remove mounting posts from the product assemblies by loosening each
setscrew.
7. One at a time, place each mounting post over anchors (notching facing
downward) and insert screws through post into anchors.
8. Tighten screws.
Topreservethenenishofthisproduct,cleanonlywithasoft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
2.54"
(64.5)
1.34"
(34.0)