Specification

 YB0409CH – Single Post Paper
Holder
Chrome Finish
 YB0409BN – Single Post Paper
Holder
Brushed Nickel Finish
25300 AL MO E N D R I VE  NO RTH O L M S TE D, OH 4 4 0 70
CO R P O RAT E HE A D Q U A RT ER S : ( 8 00 ) 3 2 1 -88 0 9  FA X: (800) 8 4 8 - 6 6 3 6
IN T E R NAT IO N A L : (440 ) 9 6 2 - 2 0 00  F A X: ( 4 4 0 ) 962 -2726
CU S T O M ER S ER V ICE ( US A): 800 -882 - 0 1 1 6  FA X: ( 88 8 ) 3 7 9 - 2720
W WW . MO E N .C O M
Copyright Creative Specialties International Literature # BA1218
Single Post Paper Holder is
constructed of zinc.
Cleaning Instructions:
Stock Number: YB0409 Single Post Paper Holder
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Single Post Paper Holder
YB0409
ALIGN
™
Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Tools Required: Phillips screwdriver, drill, 1/4” drill bit, hammer
Hardware Kit Contents: 2 anchor screws, 1 hex wrench
Note: Directions below are for installation into drywall. If installing product into a stud, use
the wood screws only.
1) Remove mounting plate from product assembly by loosening the setscrew.
2) Position the mounting plate on the wall at desired location with “UP” facing you. Mark
hole locations.
3) Drill 2 pilot holes at marked locations using 1/4” drill bit.
4) Disassemble screws and washers from anchors.
5) Lightly tap anchors until flush with the wall.
6) Place the mounting plate on the wall over the installed wall anchors with "UP" facing
you.
7) Tighten screws into the anchors until anchor is activated behind the wall WARNING:
DO NOT OVERTIGHTEN.
8) Place decorative product over the mounting plate with setscrew facing down.
9) Tighten setscrew.