Specification Sheet

Colinet™ Technical Specication
Drawer Pull YB0507
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
YB0507CH – Drawer Pull
Chrome Finish
YB0507BN – Drawer Pull
Brushed Nickel Finish
YB0507BL – Drawer Pull
Matte Black Finish
YB0507BG – Drawer Pull
Brushed Gold Finish
1. Drawer pulls will require two 3/16" holes.
2. The distance between holes is 4" on center.
3. Using a level, mark the location of the two holes.
4. Use a 3/16" drill bit to drill two holes.
5. Insert the screws into each hole.
6. Place the drawer pull over the screws.
7. Use a Phillips screwdriver to tighen screws.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Drawer Pulls are constructed of zinc.
Stock Number: _____________________ Drawer Pull
By Moen, Inc.
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2019 Moen Incorporated. Moen is a registered trademark and Colinet is a trademark of
Moen Incorporated. All rights reserved.
1-5/8"
(41mm)
1.65"
(42mm)
4"
(102mm)
4-7/16"
(113mm)
1-5/8"
(41mm)
1.65"
(42mm)
4"
(102mm)
4-7/16"
(113mm)