Dimensions Guide

Arris
™
Accessories Technical Specication
Robe Hook YB0803
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
YB0803CH – Robe Hook
Chrome Finish
YB0803BN – Robe Hook
Brushed Nickel Finish
YB0803BL – Robe Hook
Matte Black Finish
1. Remove mounting plate from the product post by loosening each setscrew.
2. Position the mounting plate on the wall at desired location with "UP" facing
you. Mark hole locations.
3. Drill 2 holes as marked using a 5/16" drill bit.
4. Fold ends of the plastic toggle anchor together and insert into each hole in the
wall.
5. Lightly tap anchors until ush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor. Remove pin and repeat on other anchor.
7. Place the mounting plate on the wall over the installed wall anchors with "UP"
facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with setscrew facing down
and tighten setscrew.
To preserve the ne nish of this product, clean only with a soft damp cloth. Dry
well. Do not use commercial or abrasive cleaners.
Robe Hook
is constructed of zinc.
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen Incorporated
Stock Number: ___________________________ Robe Hook
By Moen Incorporated
25300 AL MOEN DRIVE  NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809  FAX: [phone]
INTERNATIONAL: (440) 962- 2000  FAX: [phone]
CUSTOMER SERVICE (USA): 800- 882- 0116  FAX: [phone]
WWW.MOEN.COM
Copyright Creative Specialties International Literature #BA1717
ff
Robe Hook is constructed of zinc.
 YB0803BN – Robe Hook
Brushed Nickel Finish
 YB0803CH – Robe Hook
Chrome Finish
Cleaning Instructions:
Stock Number:______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
YB0803
Arris
TM
Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
1. Remove mounting plate from the product post by loosening each setscrew
2. Position the mounting plate on the wall at desired location with “UP” facing
you. Mark hole locations.
3. Drill 2 holes as marked using 5/16” drill bit.
4. Fold ends of the plastic toggle anchor together and insert into each hole in
the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to activate
anchor. Removepin and repeat on other anchor.
7. Place the mounting plate on the wall over the installed wall anchors with "UP"
facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with setscrew facing down
and tighten setscrew.