Dimensions Guide

Dartmoor
™
Technical Specication
YB2103
Robe Hook
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
☐ YB2103CH – Robe Hook
Chrome Finish
☐ YB2103BN – Robe Hook
Brushed Nickel Finish
☐ YB2103ORB – Robe Hook
Oil Rubbed Bronze
Robe Hook is constructed of zinc.
Stock Number: Robe Hook
By MOEN
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): [phone] • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen, Inc.
Directions below are for installation into drywall. If installing product into
a stud, use the wood screws only.
1. Using ¼” drill bit, drill one pilot hole for post.
2. Position mounting post to wall by inserting wall anchor into pilot hole
and pressing rmly.
3. Make sure that locking tab on mounting post is facing down.
4. Tighten wall anchor screw while holding mounting post rmly
in place. Tighten anchor until resistance increases. DO NOT
over tighten.
5. Using tip of screw bit press wall spikes (metal pieces on outer edge
of mounting post) into drywall.
6. Attach post by pressing rmly to mounting post until it clicks. (The
square opening at the base of the post must be facing down to
match-up with locking tab).
To preserve the ne nish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
2-13/32"
61mm
3"
75mm
1-5/8"
41mm