Dimensions Guide

Dartmoor
™
Technical Specication
YB2108
Paper Holder
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
☐ YB2108CH – Paper Holder
Chrome Finish
☐ YB2108BN – Paper Holder
Brushed Nickel Finish
☐ YB2108ORB – Paper Holder
Oil Rubbed Bronze
Paper Holder is constructed of zinc.
Stock Number: Paper Holder
By MOEN
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): [phone] • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen, Inc.
Directions below are for installation into drywall. If installing product into a stud,
use the wood screws only.
1. The center to center measurement for this product is 6 ¼".
2. Mark this distance on the wall where you want to install the product.
3. Use a level to ensure that the pilot holes will be perfectly level.
4. Using ¼" drill bit, drill one pilot hole for each post.
5. Position mounting posts to wall by inserting wall anchors into pilot holes and
pressing rmly. (Make sure that locking tab on mounting post is facing down.)
6. Tighten wall anchor screw while holding mounting post rmly in place. Tighten
anchor until resistance increases. DO NOT over tighten.
7. Using tip of screw bit press wall spikes (metal pieces on outer edge of
mounting post) into drywall.
8. Towel bar must be attached to mounting posts as a unit – insert towel bar into
each post.
9. Attach posts by pressing rmly to mounting posts until it clicks. (The square
opening at the base of the post must be facing down to match-up with
locking tab).
To preserve the ne nish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
4-13/32"
112mm
6-9/32"
160mm
3-1/2"
89mm