Installation Guide

25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: [phone]
I N TER N ATI ON AL: [phone]  FAX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International
Towel Ring post is constructed of
zinc. Ring is aluminum.
 YB2286BN – Towel Ring
Brushed Nickel Finish
 YB2286CH – Towel Ring
Chrome Finish
 YB2286ORB – Towel Ring
Oil Rubbed Bronze Finish
Cleaning Instructions:
Directions below are for installation into drywall. If installing product
into a stud, use the wood screws only.
1. Using ¼” drill bit, drill one pilot hole for post.
2. Position mounting post to wall by inserting wall anchor into pilot
hole and pressing firmly.
3. Make sure that locking tab on mounting post is facing down.
4. Tighten wall anchor screw while holding mounting post firmly in
place. Tighten anchor until resistance increases. DO NOT over
tighten.
5. Using tip of screw bit press wall spikes (metal pieces on outer
edge of mounting post) into drywall.
6. Attach post by pressing firmly to mounting post until it clicks. (The
square opening at the base of the post must be facing down to
match-up with locking tab).
Stock Number:______________________Towel Ring
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Towel Ring
YB2286
Brantford™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Literature #BA1397