Specification

Glyde™ Accessories Technical Specication
Towel Ring YB2386
Stock Numbers:
Materials:
Dimensions:
Installation Instructions:
Cleaning Instructions:
YB2386BN – Towel Ring
Brushed Nickel Finish
YB2386CH – Towel Ring
Chrome Finish
Directions below are for installation into drywall. If installing product into a stud,
use the wood screws only.
1. Using ¼” drill bit, drill one pilot hole for post.
2. Position mounting post to wall by inserting wall anchor into pilot hole and
pressing rmly.
3. Make sure that locking tab on mounting post is facing down.
4. Tighten wall anchor screw while holding mounting post rmly in place.
Tighten anchor until resistance increases. DO NOT over tighten.
5. Using tip of screw bit press wall spikes (metal pieces on outer edge of
mounting post) into drywall.
6. Attach post by pressing rmly to mounting post until it clicks. (The square
opening at the base of the post must be facing down to match-up with
locking tab).
To preserve the ne nish of this product, clean only with a soft damp
cloth. Dry well. Do not use commercial or abrasive cleaners.
Towel Ring post is constructed of zinc.
Ring is aluminum.
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen Incorporated
Stock Number: _______________________ Towel Ring
By Moen Incorporated
6-5/16"
(160mm)
1-3/4"
(45mm)
3-7/16"
(86mm)