How to Guide

25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006 Literature #BA1506
Robe Hook
is constructed of
zinc
.
q
YB2
4
03BN
–
Robe Hook
Brushed Nickel Finish
q YB2403CH – Robe Hook
Chrome Finish
Cleaning Instructions:
This product features the Pro+Fit Installation Mounting System. If you do not have the
Pro+Fit Installation Template please use the following instructions. (Note: only one
hole is required per mounting post.)
1. Mark on the wall where you want to install the product.
2. Using ¼” drill bit, drill one pilot hole for the post.
3. Position mounting post to wall by inserting wall anchor into pilot hole and
pressing firmly.
4. Make sure that locking tab on mounting post is facing down (6 o’clock).
5. Tighten wall anchor screw while holding mounting post firmly in place. DO NOT
over tighten.
6. Using tip of screw bit press wall spikes (metal pieces on outer edge of mounting
post) into drywall.
7. Attach post by pressing firmly to mounting post until it clicks. (The square
opening at the base of the post must be facing down to match-up with locking
tab.)
Stock Number:
______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
YB2403
Method™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.