Specification Sheet

25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
©Copyright Creative Specialties International Literature #BA1566
Drawer Pulls are constructed of zinc.
 YB5407BN – Drawer Pull
Brushed Nickel Finish
 YB5407CH – Drawer Pull
Chrome Finish
 YB5407ORB – Drawer Pull
Oil Rubbed Bronze Finish
Cleaning Instructions:
1. Drawer pulls will require two 3/16” holes.
2. The distance between holes is 3” on center.
3. Using a level, mark the location of the two holes
4. Use a 3/16” drill bit to drill two holes.
5. Insert the screws into each hole.
6. Place the drawer pull over the screws.
7. Use a Phillips screwdriver to tighten screws.
Materials: Installation Instructions:
Stock Numbers:
Dimensions:
Drawer Pull
YB5407
Kingsley™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dr
y
well. Do not use commercial or abrasive cleaners.
Stock Number:______________________Drawer Pull
By Creative Specialties