Installation Guide

25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006 Literature #BA1338
Paper Holder
is constructed of
zinc
.
q
YB58
08BN
–
Pivoting Paper
Holder
Brushed Nickel Finish
q YB5808CH – Pivoting Paper
Holder
Chrome Finish
Cleaning Instructions:
This product features the Pro+Fit Installation Mounting System. If you do not have the
Pro+Fit Installation Template please use the following instructions. (Note: only one
hole is required per mounting post.)
1. Find the appropriate center to center measurement for the product you are
installing.
2. Mark that distance on the wall where you want to install the product.
3. Use a level to ensure that the pilot holes will be perfectly level.
4. Using ¼” drill bit, drill one pilot hole for each post, 6 ¼ apart.
5. Position mounting post to wall by inserting wall anchor into pilot hole and pressing
firmly.
6. Make sure that locking tab on mounting post is facing down (6 o’clock).
7. Tighten wall anchor screw while holding mounting post firmly in place. DO NOT
over tighten (6 – 8 full turns will secure the anchor).
8. Paper holder must be attached to mounting posts as a unit – insert paper holder
into each post.
9. Attach posts by pressing firmly to mounting posts until it clicks. (The square
opening at the base of the post must be facing down to match-up with locking tab.)
If you are mounting any parts into a hard surface snap off the anti-rotation fins on the
back of the mounting posts.
Stock Number:
______________________Paper Holder
By Creative Specialties
Materials:
Installation Instruction
s:
Stock Numbers:
Dimensions:
Paper Holder
YB5808
Icon™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.