Dimensions Guide

Beleld™ Accessories Technical Specication
Tank Lever YB6401
Stock Numbers:
Materials:
YB6401CH – Tank Lever
Chrome
YB6401BN – Tank Lever
Brushed Nickel
YB6401ORB – Tank Lever
Oil Rubbed Bronze
YB6401NL – Tank Lever
Polished Nickel
Installation Instructions:
1. Remove existing tank lever.
2. Remove the arm mechanism from the new tank lever by loosening nut.
3. Unscrew the tank nut. The thread for the tank nut is a left handed thread.
4. Position the new tank lever through the tank hole. The tank lever
handle should be pointing away from the toilet bowl.
5. Tighten nut. Depending on the curvature of the tank, there might be a
slight gap between the outside of the tank and the base of the lever.
6. Place the arm mechanism on the tank lever post. Adjust the arm up
or down as needed. Tighten nut to secure the arm in place.
7. Adjust the arm mechanism from side to side as needed. Make sure
the arm does not come into contact with the tank wall or the ush
mechanism. Tighten screw to lock the arm in place
8. Attach the apper valve chain to one of the provided slots on the
arm. Be sure to eliminate any slack in the chain.
9. Make sure no water is leaking through the apper when the handle is
in its normal position (not ushing).
Tank Lever is constructed of zinc.
The arm mechanism is constructed of
plastic.
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©Copyright Moen Incorporated
Stock Number: _______________________ Tank Lever
By Moen Incorporated
Dimensions:
1.7"
43mm
4.45"
113mm
10"
255mm
Cleaning Instructions:
To preserve the ne nish of this product, clean only with a soft damp
cloth. Dry well. Do not use commercial or abrasive cleaners.