Installation Guide

Robe Hook is constructed of zinc.
 YB8003CH – Robe Hook
Chrome Finish
 YB8003OWB – Robe Hook
Old World Bronze Finish
 YB8003PB – Robe Hook
Polished Brass Finish
 YB8003BC – Robe Hook
Brushed Chrome Finish
 YB8003SN – Robe Hook
Satin Nickel Finish
25300 AL MOEN D R I VE  NOR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: (800) 848 -6636
I NTER N ATI ON AL: (440) 962 -2000  F AX: [phone]
C USTOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W WW . MOEN . C OM
Copyright Creative Specialties International Literature #BA1227
Cleaning Instructions:
1. Locate position where robe hook should be installed.
2. Using ¼” drill bit, drill one pilot hole.
3. Position mounting post to wall by inserting wall anchor into pilot hole
and pressing firmly.
4. Make sure that locking tab on mounting post is facing down (6
o’clock).
5. Tighten wall anchor screw while holding mounting post firmly in
place.
6. Attach robe hook by pressing firmly to mounting post until it clicks.
(The square opening at the base of the post must be facing down to
match-up with locking tab.)
7. Place spring roller into each post.
Stock Number:______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
YB8003
Mason® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.