Specification

1. Drawer pulls will require 3/16” holes.
2. The distance between holes is 3” on center.
3. Using a level, mark the location of the two holes.
4. Use a 3/16” drill bit to drill two holes.
5. Insert the screws into each hole.
6. Place the drawer pull over the screws.
7. Use a Phillips screwdriver to tighten screws.
25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  FAX: [phone]
I N TERN ATI ON AL: (440) 962 -2000  F AX: [phone]
C U STOMER SERVI C E (U SA): 800 -882-0116  FAX: [phone]
W W W .MOEN .C OM
Copyright Creative Specialties International Literature #BA1562
Drawer Pulls are constructed of zinc.
 YB8207BN – Drawer Pull
Brushed Nickel Finish
 YB8207CH – Drawer Pull
Chrome Finish
 YB8207ORB – Drawer Pull
Oil Rubbed Bronze Finish
Cleaning Instructions:
Stock Number:______________________Drawer Pull
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Drawer Pull
YB8207
Rothbury™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.