Specification Sheet

Weymouth
®
Technical Specication
Decorative Tank Lever YB8401
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
YB8401BN – Decorative Tank Lever
Brushed Nickel Finish
YB8401CH – Decorative Tank Lever
Chrome
Finis
h
YB8401ORB – Decorative Tank Lever
Oil Rubbed Bronze Finish
YB8401NL – Decorative Tank Lever
Polished Nickel Finish
YB8401BG – Decorative Tank Lever
Brushed Gold
1. Remove existing tank lever.
2. Remove the brass arm mechanism from the new tank lever by loosening screw A.
3. Position the new tank lever through the tank hole. The tank lever handle
should be pointing away from the toilet bowl.
4. Install the brass nut inside the tank and tighten. Depending on the curvature of
the tank, there might be a slight gap between the outside of the tank and the
base of the lever.
5. Loosen, but do not remove screw on the arm mechanism.
6. Tighten screw A.
7. Adjust the brass arm mechanism so it does not come in contact with the tank
wall or any part of the ush mechanism parts inside the tank.
8. Tighten the adjustment screw (screw B) on the brass arm mechanism
9. Attach the apper valve chain to one of the three holes provided slots on the
brass arm.
10. Make sure that the arm does not activate, and no water is leaking through the
apper valve when the handle is in its normal position, (not ushing).
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Tank Levers are constructed of zinc. Arm
mechanism is brass.
Stock Number: _____________________ Tank Lever
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2018 Moen Incorporated. Moen is a registered trademark and Voss is a trademark of
Moen Incorporated. All rights reserved.
A
B
1.5"
(37mm)
2.8"
(71mm)