Specification Sheet

 YB8807BN – Drawer Pull

Brushed Nickel Finish

 YB8807CH – Drawer Pull

Chrome Finish

25300 AL MOEN DR I VE  NOR TH OLMSTED , OH 44070

C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  FAX: (800) 848-6636

I NTER NATI ON AL: (440) 962 -2000  F AX: (440) 962-2726

C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: (888) 379-2720

W W W . MOEN . C OM

Copyright Creative Specialties International Literature # BA1559

Drawer Pulls are constructed of zinc.

Cleaning Instructions:

1. Draw er pulls w ill require tw o 3/16” holes.

2. The distance betw een holes is 3” on center.

3. Using a level, mark the location of the tw o holes.

4. Use a 3/16” drill bit to drill tw o holes.

5. Insert the screw s into each hole.

6. Place the draw er pull over the screw s.

7. Use a Phillips screw driver to tighten screw s.

Stock Number:______________________Drawer Pull

By Creative Specialties

Materials:

Installation Instructions:

Stock Numbers:

Dimensions:

Drawer Pull

YB8807

90°™ Technical Specification

To preserve the fine finish of this product, clean only with a soft

damp cloth. Dry well. Do not use commercial or abrasive cleaners.

PAGE 1
90°™ Technical Specification Drawer Pull Stock Numbers:  YB8807BN – Drawer Pull Brushed Nickel Finish  YB8807CH – Drawer Pull Chrome Finish Materials: Drawer Pulls are constructed of zinc. YB8807 Dimensions: Installation Instructions: 1. 2. 3. 4. 5. 6. 7. Draw er pulls w ill require tw o 3/16” holes. The distance betw een holes is 3” on center. Using a level, mark the location of the tw o holes. Use a 3/16” drill bit to drill tw o holes. Insert the screw s into each hole.