Full Product Manual

Tank Lever is constructed of zinc.
 YB9801CH – Tank Lever
Chrome Finish
 YB9801BN – Tank Lever
Brushed Nickel Finish
 YB9801WR – Tank Lever
Wrought Iron Finish
 YB9801ORB – Tank Lever
Oil Rubbed Bronze Finish
 YB9801NL – Tank Lever
Nickel Finish
Cleaning Instructions:
25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  F AX: (800) 848 -6636
I N TER N ATI ON AL: [phone]  F AX: (440) 962 -2726
C U STOMER SER VIC E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Creative Specialties International Literature #BA1484
Stock Number:______________________Tank Lever
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Tank Lever
YB9801
Waterhill® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
1. Remove existing tank lever.
2. Remove the brass arm mechanism from the new tank lever by loosening
screw A.
3. Position the new tank lever through the flush tank hole.
4. The tank lever handle should be pointing away from the toilet bowel.
5. Install the brass nut inside the tank and tighten. Depending on the
curvature of the tank, there might be a slight gap between the outside of
the tank and the base of the lever.
6. Loosen, but do not remove screw B on the arm mechanism.
7. Replace the entire brass arm mechanism onto the tank lever.
8. Tighten screw A.
9. Adjust the brass arm mechanism so it does not come in contact with the
tank wall or any part of the flush mechanism parts inside the tank.
10. Tighten the adjustment screw (screw B) on the brass arm mechanism.
11. Attach the flapper valve chain to one of the three holes provided on the
brass arm.
12. Make sure that the arm does not activate, and no water is leaking thru
the flapper valve when the handle is in the normal position, (not
flushing