Use and Care Guide

Robe Hook
is constructed of zinc.
q
YB98
03
CH
–
Robe Hook
Chrome Finish
q YB9803BN – Robe Hook
Brushed Nickel Finish
q YB9803WR – Robe Hook
Wrought Iron Finish
Cleaning Instructions:
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800- 882- 0116 • FAX: [phone]

Copyright Creative Specialties International 2004 Literature #BA1185
1.
Remove the m
ounting bracket
from the body by l
oosening the setscrew.
2. Position the assembled unit on the wall where desired.
3. Lightly mark the outline of each base.
4. Center a mounting bracket within the base outline with “UP” facing you.
5. One at a time, place each anchor
screw through the mounting plate, centered
in each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self drill and tap into drywall. Do not over
tighten.
6. Place the post with the setscrew down, over mounting bracket. Tighten the
setscrew at the bottom of the base.
Stock Number:
______________________Robe Hook
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Robe Hook
YB9803
Waterhill™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.