Dimensions Guide

25300 AL MO E N D R I VE  NO RTH O L M S TE D, OH 4 4 0 70
CO R P O RAT E HE A D Q U A RT ER S : ( 8 00 ) 3 2 1 -88 0 9  FA X: (800) 8 4 8 - 6 6 3 6
IN T E R NAT IO N A L : (440 ) 9 6 2 - 2 0 00  F A X: ( 4 4 0 ) 9 6 2 -2726
CU S T O M ER S ER V ICE ( US A): 800 -882 - 0 1 1 6  FA X: ( 88 8 ) 3 7 9 - 2720
W WW . CSI . MOE N . C O M
Copyright Creative Specialties International Literature # BA1736
Grab Bar posts and bars are
constructed of stainless steel.
 YG0712CH – 12” Grab Bar
Chrome Finish
 YG0718CH – 18” Grab Bar
Chrome Finish
 YG0724CH – 24” Grab Bar
Chrome Finish
 YG0736CH – 36” Grab Bar
Chrome Finish
 YG0742CH – 42” Grab Bar
Chrome Finish
 YG0712BN – 12” Grab Bar
Brushed Nickel Finish
 YG0718BN – 18” Grab Bar
Brushed Nickel Finish
 YG0724BN – 24” Grab Bar
Brushed Nickel Finish
 YG0736BN – 36” Grab Bar
Brushed Nickel Finish
 YG0742BN – 42” Grab Bar
Brushed Nickel Finish
Cleaning Instructions:
1. Please note that screws MUST be mounted into a wood stud for secure installation.
2. Decide whether you would like to position your grab bar horizontally, vertically or at an angle,
remembering that BOTH ends of the grab bar MUST be positioned over a wood stud (unless using
secure mount anchors).
3. For easier installation and mounting remove 3 setscrews from each flange and remove bar from
SecureMount™ Flange.
4. Remove cover and re-assemble flange to bar by tightening 3 set screws.
5. Place grab bar and mark three mounting locations on each of the two grab bar flanges with a pencil.
6. Drill 1/8 diameter pilot holes at each screw location. Make sure to drill into the stud.
7. Install 3 screws and washers each SecureMount™ flange and tighten until secure. If desired, apply
silicone caulk to the back of the SecureMount™ plate to guard against water penetration.
8. After screws are installed each side, dis-assemble bar from SecureMount™ flange by removing set
screws.
9. Re-install covers.
10. Place bar over SecureMount™ flanges and tighten all set screws.
11. Snap on covers.
Stock Number:______________________Grab Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Grab Bar
YG0712/YG0718/YG0724/YG0736/YG0742
Iso
®
Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.