Specification

Voss
™
Technical Specication
YG5112, YG5118, YG5124
Grab Bar
Stock Numbers:
Materials:
Compliance:
Dimensions:
Installation Instructions:
Cleaning Instructions:
☐ YG5112CH – 12" Grab Bar
Chrome Finish
☐ YG5118CH – 18" Grab Bar
Chrome Finish
☐ YG5124CH – 24" Grab Bar
Chrome Finish
☐ YG5112BN – 12" Grab Bar
Brushed Nickel Finish
☐ YG5118BN – 18" Grab Bar
Brushed Nickel Finish
☐ YG5124BN – 24" Grab Bar
Brushed Nickel Finish
☐ YG5112ORB – 12" Grab Bar
Oil Rubbed Bronze Finish
☐ YG5118ORB – 18" Grab Bar
Oil Rubbed Bronze Finish
☐ YG5124ORB – 24" Grab Bar
Oil Rubbed Bronze Finish
Grab Bar posts and bars are constructed of
stainless steel.
• ADA, ANSI, ASTM, CSA
• Tested to 500lbs. pull
Stock Number: Grab Bar
By MOEN
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: [phone] • FAX: [phone]
CUSTOMER SERVICE (USA): [phone] • FAX: [phone]
WWW.MOEN.COM
©
Copyright Moen, Inc.
1. Please note that screws MUST be mounted into a wood stud for secure installation.
2. Decide whether you would like to position your grab bar horizontally, vertically or at an
angle, remembering that BOTH ends of the grab bar MUST be positioned over a
wood stud (unless using secure mount anchors).
3. For easier installation and mounting remove 3 set screws from each ange and remove
bar from SecureMount™ Flange.
4. Remove cover and re-assemble ange to bar by tightening 3 set screws.
5. Place grab bar and mark three mounting locations on each of the two grab bar anges
with a pencil.
6. Drill 1/8” diameter pilot holes at each screw location. Make sure to drill into the stud.
7. Install 3 screws and washers each SecureMount™ ange and tighten until secure. If
desired, apply silicone caulk to the back of the SecureMount™ plate to guard against
water penetration.
8. After screws are installed each side, dis-assemble bar from SecureMount™ ange by
removing set screws.
9. Re-install covers.
10. Place bar over SecureMount™ anges and tighten all set screws.
11. Snap on covers.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
2-5/8"
(67mm)
1-1/2"
(38mm)
1-1/4"
(32mm)
3-1/8"
(79mm)
A
B
Dim. A Dim. B
YG5112 12 15.125
YG5118 18 21.125
YG5124 24 27.125