User's Guide

3. Pick 2 or 3 feet (matching the numbers in step 1), attach a silicone foot bumper to the
bottom of each foot.
4. Attach a threaded rod of the length you think would work and attach to the foot, by
rotating until it touches the silicone bumper.
5. Screw two M4 nuts onto the threaded rod. The first M4 nut should be screwed on hard
against the foot. The second M4 nut should be loose on the threaded rod.
6. Now attach the threaded rods and feet into the legs in step 1. Adjust the height of each
foot until the Glove80 half is stable on the desk and at the tenting angle you desire.
7. Once you have completed adjusting the tenting angle, turn the loose M4 nut on each
threaded rod until it is hard against the plastic case of the half keyboard.
NOTE: If you desire even higher angle mounting, please see the section on Custom Mounting.
Pae 27 Glove80 User Guide