User's Guide

2. For the non-extensible legs, use a craft knife to remove the silicone bumper, to reveal a
M4 stud.
3. Attach M4 threaded rods or M4 screws and use other appropriate fasteners such as nuts
to secure Glove80 onto your custom mounting mechanism.
Attaching Tripod Mounting Plate
MoErgo makes available mounting plates for Glove80 to easily attach to camera tripod and
other mounts using the standard tripod mount screws (1/4"-20).
To mount the tripod plate onto a Glove80 half:
1. Follow the instructions in the How to custom mount section.
2. Turn the half upside down.
3. Add a foot without a silicone bumper, as a spacer, for each extensible leg.
4. Put the tripod mounting plate over the up-turned half, lining up the holes in the tripod
mounting plate with the legs.
5. Screw each original foot with threaded rods (through the spacer foot if one exists) into
the M4 stud in the leg.
Pae 31 Glove80 User Guide