Specifications

Maintenance—Every 250 Hours
TX,75,JC1109 –19–18MAR96–3/4
T7829AH –UN–31AUG92
544G Shown
T7829AI –UN–31AUG92
624G Shown
T100692 –UN–22MAR96
644G Shown
8. Turn filter (A) counterclockwise to remove.
9. Clean mounting surface. Apply thin film of oil to gasket
of new filter.
10. Install new filter. Turn filter clockwise by hand until
gasket touches mounting surface.
11. Tighten 1/2—3/4 turn more.
12. Tighten drain valve.
13. Remove filler cap (B).
14. Fill engine with oil. (See Fuels and Lubricants
chapter.)
SPECIFICATION
Includes filter change:
544G, LL, TC, 624G 19 L (20 qt)
644G 24 L (25 qt)
15. Install filler cap.
IMPORTANT: Before starting engine after a filter
change, crank engine for 10 seconds
without starting to refill filter and
prelubricate turbocharger.
16. Remove engine shut-off fuse.
Crank engine for 10 seconds using starting motor.
Install engine shut-off fuse.
17. Start engine and run at slow idle.
18. Check that engine oil pressure light on monitor goes
out and audible alarm stops immediately. If not, stop
engine immediately and find cause.
19. Stop the engine. Check oil level. The engine is full
when oil level is in the cross hatched area on the
dipstick.
75–4
PN=136