Specifications

Maintenance
TX,90,JC1115 –19–18MAR96–1/1
BLEEDING FUEL SYSTEM—644G
T100696 –UN–22MAR96
A—Final Fuel Filter
B—Bleed Screw
C—Bleed Screw
D—Pump
E—Fuel Supply Line
F—Primary Fuel Filter
G—Drain Valve
1. Place container under primary fuel filter (F).
2. Loosen bleed screw (C), and push pump (D) until fuel
free of bubbles flows from around bleed screw.
3. Tighten bleed screw.
4. Loosen bleed screw (B) from final fuel filter (A), and
push pump (D) until fuel free of bubbles flows from
around bleed screw.
TX,90,DH2534 –19–16JUN93–1/1
ADJUSTING FUEL SHUT-OFF SOLENOID—
644G
T8030AM –UN–21JUN93
A—Linkage
B—Shut-off Lever
1. Disconnect linkage (A) from fuel shut-off lever (B).
2. Hold shut-off lever against lower position stop.
3. Adjust linkage so linkage aligns with hole in shut-off
lever, and turn out two complete turns.
NOTE: Failure to have the shut-off lever against upper
position stop can result in low engine horsepower.
4. Start engine and make sure shut-off lever is tight
against upper position stop.
90–8
PN=174