Specifications

Maintenance
TX,90,RR,1725 –19–11MAR94–2/2
T6249AU –UN–19OCT88
A—Flange Nut
B—Lock Washer
C—Housing
D—Bulb
E—Gasket
F—Lens
G—Bezel
H—Screw
1. Remove four screws (H) to remove bezel (G) and lens
(F).
2. Disconnect wiring lead and release retainer clip to
remove bulb (D).
3. To disconnect ground wiring lead, push tab up, then
pull connector from terminal.
IMPORTANT: Do not touch the halogen bulb with
bare hands. Oil and moisture may
cause premature bulb failure. Clean
bulb using a soft, oil-free cloth and
alcohol.
4. Install new bulb so square notch is aligned with square
tab on reflector back.
5. Install retainer clip into locking tabs on reflector back.
6. Connect wiring leads. Check wiring leads are free of
clip.
7. Install lens assembly (F) in housing (C) making sure
wires are not crimped, or keeping lens assembly from
seating on gasket.
8. Install bezel so wider section is on top. Sealing flange
must be inside housing on all four sides before
tightening screws.
9. Tighten screws alternately. Do not overtighten as
screws may strip out plastic.
90–17
PN=183