Specifications

Maintenance
T82,SKMA,AT –19–01AUG94–1/1
HARDWARE TORQUE SPECIFICATIONS
Check cap screws and nuts to be sure they are tight. If
hardware is loose, tighten to torque shown on the
following charts unless a special torque is specified.
04T,90,MM8 –19–25JUN91–1/1
KEEP ROPS INSTALLED PROPERLY
TS176 –UN–23AUG88
Ö
CAUTION: Make certain all parts are reinstalled
correctly if the roll-over protective structure
(ROPS) is loosened or removed for any reason.
Tighten mounting bolts to proper torque.
The protection offered by ROPS will be
impaired if ROPS is subjected to structural
damage, is involved in an overturn incident, or
is in any way altered. A damaged ROPS should
be replaced, not reused.
When installation of equipment on a machine necessitates
loosening or removing ROPS, mounting bolts must be
tightened to 620 ± 120 N•m (457 ± 88 lb-ft).
90–30
PN=196